1686-20
Knurled Parallel Jaw Grip 4-3/8-Inch Length
- Longer jaws achieve a firm hold, reducing possibility of slippage and damage to cable
- Design includes a latch, plus a large-diameter eye that accommodates large hooks on hoists, winches and tackle blocks
- When latch is closed, it helps maintain cable position in grip jaws
- Same as Cat. No. 1686-10, but with knurled jaws
- Made in USA
Longer knurled jaws achieve a firm hold, reducing possibility of slippage and damage to cable. Design includes a latch, plus a large-diameter eye that accommodates large hooks on hoists, winches and tackle blocks. When latch is closed, it helps maintain cable position in grip jaws.
Specifications
Type:
Parallel Jaw Grip
Application:
Wire Pulling
Special Features:
Longer Jaw and Large Diameter Eye
Overall Length:
7.2'' (18.3 cm)
Material:
Steel
Cable Type:
Aircraft, Messenger, Guy Strand
Cable Diameter:
0.2'' to 0.4'' (5.08 to 10.16 mm)
Hot Latch:
N
Swing Latch:
N
Spring:
N
Locking Handle:
N
Jaw Type:
Double V
Teeth Type:
Coarse
Jaw Length:
4.375'' (11.1 cm)
Maximum Safe Load:
10,000 lb (4536 kg)
Weight:
4.6 lb (2.1 kg)
UPC:
092644471810
Additional Information
Warnings
- Before each use, clean jaw area and inspect grip for proper operation to avoid slippage.
- When used on/near energized lines, ground, insulate, or isolate grip before pulling.
- Do not exceed rated capacity.
- Always match proper size and type of grip to application.
- Grips are to be used for temporary installation, not for permanent anchorage.
