1005RINS
Crimping and Cutting Tool for Connectors, Insulated
- Crimper crimps insulated and non-insulated 10-22 AWG solderless terminals and connectors
- Individually tested to meet or exceed ASTM F1505-16 and IEC 60900 standards for insulated tools, and clearly marked with the official 1000V rating symbol
- Wire cutter in nose that is tapered for working in confined spaces, and induction hardened cutting knives for long life
- Flame retardant, impact-resistant, bright orange and gray outer coating
- Made in USA
- Multi-layer grip provides comfort and protection against electrical shock
- Hot-riveted joint for smooth action and no handle wobble
The 7MÊÓƵ Insulated Crimping/Cutting Tool crimps wire from 10 to 22 AWG. This crimper/cutter features a tapered nose for working in confined spaces. Additionally, it features bright orange outer coating on the handles that is flame retardant and impact resistant.
Specifications
Type:
Combination Cutter Crimper
Application:
For Work Near Energized Sources
Special Features:
Flame Retardant and Impact Resistant Handle
Overall Length:
9.83'' (25 cm)
Overall Height:
1.28'' (3.3 cm)
Overall Width:
2.56'' (6.5 cm)
Material:
Induction Hardened Steel
Nose Type:
Tapered
Jaw Length:
1.3'' (3.3 cm)
Jaw Width:
0.16'' (0.4 cm)
Cutting Knives:
Standard
Knife Length:
0.560'' (1.4 cm)
Cut Style:
Knife on Anvil
Strips and Cuts AWG Solid:
10-22
Strips and Cuts AWG Stranded:
10-22
Joint Type:
Hot-Riveted
Handle Color:
Orange/Light Gray
Handle Material:
High-Dielectric Plastic Cushion Grip
Handle Finish:
2-Layer Insulation
Handle Length:
5.73'' (14.6 cm)
Insulated:
Yes
Tether Capable:
No
Weight:
13.8 oz (391 g)
UPC:
092644742019
Warnings
- Whenever possible, always de-energize lines and equipment prior to working on or around them. Klein insulated tools are designed only to reduce the chance of injury where the tool may make contact with an energized source.
- Only use tools that are marked with the official international 1000-volt rating symbol shown below, if there is any chance that the tools will make contact with an energized source.
- Always inspect your tools before use.
- Always wear approved eye protection.
- Do NOT touch uninsulated portion of the tool or any conductive object when either might contact an energized source.
